[Keyboard] Add Support to Ducky One2 SF (#17260)

keyboards/ducky/one2sf/1967st/mcuconf.h

@@ -0,0 +1,51 @@
+/*
+  ChibiOS - Copyright (C) 2020 Alex Lewontin
+
+  Licensed under the Apache License, Version 2.0 (the "License");
+  you may not use this file except in compliance with the License.
+  You may obtain a copy of the License at
+
+    http://www.apache.org/licenses/LICENSE-2.0
+
+  Unless required by applicable law or agreed to in writing, software
+  distributed under the License is distributed on an "AS IS" BASIS,
+  WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+  See the License for the specific language governing permissions and
+  limitations under the License.
+*/
+
+#ifndef _MCUCONF_H_
+#define _MCUCONF_H_
+
+/*
+ * Board setting
+ * The following settings override the default settings present in
+ * the various device driver implementation headers.
+ * Note that the settings for each driver only have effect if the whole
+ * driver is enabled in halconf.h.
+ *
+ * IRQ priorities:
+ * 3...0       Lowest...Highest.
+ *
+ * DMA priorities:
+ * 5...0        Lowest...Highest.
+ */
+
+/*
+ * HAL driver system settings.
+ */
+#define NUC123_HSE_ENABLED TRUE
+#define NUC123_PLL_ENABLED TRUE
+#define NUC123_PLLSRC NUC123_PLLSRC_HSE
+#define NUC123_HCLKSRC NUC123_HCLKSRC_PLL
+#define NUC123_HCLKDIV 2
+#define NUC123_PLL_NF 144
+#define NUC123_USB_USE_USB0 TRUE
+#define NUC123_USB_USE_USB1 TRUE
+
+#define NUC123_SERIAL_USE_UART0 TRUE
+#define NUC123_SERIAL_CLKSRC NUC123_SERIAL_CLKSRC_HSI
+
+#define NUC123_MCUCONF
+
+#endif /* _MCUCONF_H_ */