[Core] usb_device_state: consolidate usb state handling across implementations (#24258)

* usb_device_state: add idle_rate, led and protocol

Previously all usb drivers and platform implementations (expect for our
oddball atsam) tracked the same two global variables:

- keyboard_protocol: to indicate if we are in report or boot protocol
- keyboard_idle: for the idle_rate of the keyboard endpoint

And a local variable that was exposed trough some indirection:

- keyboard_led_state: for the currently set indicator leds (caps lock etc.)

These have all been moved into the usb_device_state struct wich is
accessible by getters and setters.

This reduces code duplication and centralizes the state management
across platforms and drivers.

Signed-off-by: Stefan Kerkmann <karlk90@pm.me>

* usb_device_state: reset protocol on reset

The usb hid specification section 7.2.6 states:

When initialized, all devices default to report protocol. However the
host should not make any assumptions about the device’s state and should
set the desired protocol whenever initializing a device.

Thus on reset we should always do exactly that.

Signed-off-by: Stefan Kerkmann <karlk90@pm.me>

* keyboards: fix oversize warnings

Signed-off-by: Stefan Kerkmann <karlk90@pm.me>

---------

Signed-off-by: Stefan Kerkmann <karlk90@pm.me>

drivers/haptic/solenoid.c

@@ -158,7 +158,7 @@ void solenoid_setup(void) {
 #endif
         gpio_write_pin(solenoid_pads[i], !solenoid_active_state[i]);
         gpio_set_pin_output(solenoid_pads[i]);
-        if ((!HAPTIC_OFF_IN_LOW_POWER) || (usb_device_state == USB_DEVICE_STATE_CONFIGURED)) {
+        if ((!HAPTIC_OFF_IN_LOW_POWER) || (usb_device_state_get_configure_state() == USB_DEVICE_STATE_CONFIGURED)) {
             solenoid_fire(i);
         }
     }